Publicidad
5.3 Pull up on tank lid to separate from the base.
5.4 Pour dirty water into sink.
5.5 Check foam filter for debris before reassembly. If
filter has debris, rinse with water.
5.6 When finished emptying the tank, simply place lid
back onto the tank and make sure to latch the tabs
on each side back into the locked position.
5.7 Tilt tank straight into position until latch snaps in
place.
RECOMMENDED CLEANING SEQUENCE
NOTE: Your HOOVER
FloorMate™ Hard Floor Cleaner may be used to clean wood floors that have been
®
sealed with a polyurethane coating and can be cleaned with water.
To prevent damage to wood floors, follow the flooring manufacturer's cleaning recommendations. If using
cleaner on sealed wood floors, inspect floor surface for worn finish, bare wood or separated joints. Do not
use FloorMate
Hard Floor Cleaner to clean sealed wood floors if any of these conditions exist.
TM
6.1 Vacuum floor to remove loose dirt, hair and
debris.
6.2 Fill Clean Water Solution Tank with Hoover
Cleaning Solution and water (refer to 3.1 thru 3.7).
IMPORTANT
Do not use solvent based cleaning concentrates
in your cleaner. Do not use any type of wax in
your cleaner.
Dry hands and plug cleaner into a properly
grounded outlet.
6.3 Step on handle release pedal and lower handle
to operating position.
6.4 Turn cleaner ON.
CAUTION
!
Do not clean over floor electrical outlets.
5.3
5.5
6. HOW TO CLEAN
CAUTION
!
6.1
6.4
!
9
5.4
5.7
!
6.3
Publicidad
