Yissvic MK1000-UL Manual De Instrucciones página 6

II. Warm milk froth (thin foam)
1. Place the appliance on a flat surface.
2. Then open the lid, insert the frothing whisk onto the shaft on the bottom of
frother.
3. Fill the frother with the desired amount of milk, and cover with the lid.
Note:
To avoid milk overflowing while frothing, the max quantity for frothing
milk is 150ml (5.1oz) (see Fig. 1), The min quantity for frothing milk is 75ml
(2.5oz).
Please use whole milk or semi-skimmed at refrigerator temperature (about
6-8 °C).
4. Connect the plug to the power supply.
5. Press the FUNTION button twice, the working indicator of "Warm milk froth (thin
foam)" will flash. Then press the ON/OFF button, the frother will start to work.
Once it is finished, the frother will stop.
Note: During operation, you can stop frothing by pressing the ON/OFF button
once.
6. When the frother has stopped operating, open the lid, pour out the warmed and
frothed milk to enjoy it.
7. Always turn off the milk frother and disconnect the power supply when not use.
III. Heat milk
1. Place the appliance on a flat surface.
2. Then open the lid, insert the frothing whisk onto the shaft on the bottom of
frother.
3. Fill the frother with the desired amount of milk, and cover with the lid.
Note: To avoid milk overflowing while heating, the max quantity for heating
milk is 300ml (10.2oz) (see Fig. 1), The min quantity for heating milk is 75ml
(2.5oz).
4. Connect the plug to the power supply.
5. Press the FUNTION button three times, the working indicator of "Heat milk" will
flash. Then press the ON/OFF button, the appliance
will start to work. Once the temperature of milk has achieved the setting value, the
frother will stop working;
6. When the frother has stopped operating, open the lid, pour out the warm milk
and enjoy it.
7. Always turn off the milk frother and disconnect the power supply when not use.
-EN.05-