Hoover Asciugatrice NDP Manual De Instrucciones página 58

2. DRAIN HOSE KIT
To avoid emptying the water container after
each drying cycle, the water can be
discharged directly to a waste water drain
pipe. Water Bye-Laws prohibit connection
to a surface water drain. The waste water
drain pipe should be located adjacent to the
tumble dryer.
The kit consists of: 1 hose and 1 bung.
WARNING
Switch off and remove the tumble
dryer plug from the electricity supply
before carrying out any work.
Fit the hose as follows
1. Tilt the machine slowly to the right side.
2. The waste water pipe is situated at the
right-hand side of the machine (see
the picture). A grey hose connects to
the in line connector at the left hand side
of the machine. Using pliers, remove
the pipe retaining clip from the in line
connector.
3. Pull the hose off the in line connection.
4. Place the bung supplied by the kit to
close the remaining hose.
5. Attach the black hose from the kit (using
the connector and pipe clips supplied)
to the hose removed from the in line
connection.
Once the machine is in place, check
the bottom to ensure that the new
hose does not kink when pushing the
tumble dryer into position.
58