Publicidad
Idiomas disponibles
Idiomas disponibles
•
Check the appliances for gas leaks.
•
Check the lighting and flame of the main burner.
•
We urge the user to follow the instructions when using the appliance.
MAINTENANCE
With prolonged use of the appliance, it is essential to carry out regular maintenance for the safe functioning of the
appliance; we therefore recommend drawing up a contract for after sales service.
Maintenance must be done only by specialised personnel, observing the norms in force and our indications.
SPARE PARTS
Open rings:
The cocks can be changed by removing the front panel; to change the thermocouples and burners you have to remove
Gas oven
the gas-cock, timer, thermocouples, burners and ignition plugs can be changed by accessing them inside the oven and/or
by removing the bottom oven panel or control panel..
INSTRUCTIONS FOR USE
Attention! The appliance must only be used under surveillance.
LIGHTING AND ADJUSTING THE OPEN RINGS
LIGHTING AND REGULATING THE GAS OVEN BURNER
Oven:
Turn the control knob to the right and set the temperature wanted.
To turn the oven off, turn the knob to the left to position 0.
When you want to use the oven with only the top heating element, not thermostatic, position
the knob on the
When you want to use the oven with only the bottom heating element, not thermostatic,
position the knob on the
Caution: when the oven is on the door must be kept shut otherwise the knobs and protection
sheet could get hot and be damaged.
Grill:
When using the grill the oven door must be ajar.
A protection sheet is supplied with the oven. Fix it under the control panel to protect against overheating
Remove this protection sheet only once it has cooled down. The grill gets hot when it is working so you must wear
protective gloves to remove it and to prevent burns.
Turn the oven control knob round to the
GB
the rungs and trays.
On the front panel, above each knob, the burner it corresponds to is indicated by the index
Use a lighter to light the gas: turn the knob to the left, from the "0" position to the
(see figure), hold it down and light the gas.
Keep the knob pressed a few second and then let it go, this lights the pilot.
If the flame goes out you have to repeat the procedure.
By turning the knob round to the
By turning the knob round to the
To switch off, move the knob back into position " 0".
To light, turn the knob to the left from the "0" position to any one of the positions between
and 250 (see figure); keep the knob pressed until the gas lights.
You can check the flame through the inspection hole on the bottom of the oven; after a few
seconds let got of the knob. If the flame goes out repeat the procedure. Turn the knob round
to the temperature position wanted.
To turn the oven off, turn the knob to the right until it reaches position 0.
Attention: - When the oven is working, the door must not be left open because it can heat
and probably damage the knobs.
TURNING ON AND ADJUSTING THE CONVENTIONAL OVEN
symbol.
symbol.
IE
IT
CH
position the burner is at maximum
position the burner is at minimum.
symbol.
33
sign
(see Fig. D).
Publicidad
