Zeegma Pizza Chef Manual De Usuario página 6

USE
EN Note! Before using for the first time, follow steps 1-3 without food.
1.
Connect the device to the power source and close the lid.
2.
Set the temperature controller (3, fig. A) to the maximum value
(400°C). The thermostat indicator light (4, fig. A) will light up.
3.
Set the timer (5, fig. A) for 10 minutes to preheat the device.
4.
After 10 minutes, make sure the device is preheated, then place
the frozen pizza or raw dough on the ceramic stone plate (7,
fig. A) with care.
5.
Close the lid of the device. Set the temperature controller to
the desired value and the timer to the desired time (about
4-5 minutes, or until the desired result is achieved). It is
recommended to regularly check the level of baked pizzas.
6.
To decrease or increase the baking temperature, use the
temperature controller (3, Figure A).
Note! Do not place too many pizza toppings in the device to avoid
burning the dish.
When preparing frozen pizzas, wait a few minutes after taking them
out of the freezer before placing them in the device.
It is not recommended to prepare pizzas from pourable dough.
TROUBLESHOOTING
Problem
The pizza is overbaked.
Solution
• Make sure the selected
temperature is not too
high. Set the temperature
controller to a lower value.
• Make sure the selected
baking time is not too long.
• Open the lid of the device
and leave it open for a few
minutes.