by dust, use gasoline to clean the air filter, then dip in the oil, wring oil out and put
the air filter back. (Graph 3)
Grafh 1
1. Turn on the gasoline switch until the gasoline flows out of the clear plastic
pipe. (Graph 4)
2. Close the choke totally. (Graph 5) If the engine is heated, the choke must be
totally opened.
3. Open the throttle half.
4. Draw the starter several times slowly, and then draw quickly.
Note: If the excessive gasoline causes the start to be difficult, take down the
ignition plug and the input pipe, open the choke and the throttle totally, draw the
starter several times, then install the spark plug and input pipe and start the
engine. After the startup, open the choke totally.
1. After the engine starts, run 3~5 minutes at a low speed.
2. When the engine is warm enough, adjust the throttle handle to the needed
speed.
1: The FC 2 stroke
Upper level
engine oil
50: Gasoline
Ⅳ. STARTUP
Ⅴ. RUNNING
Grafh 2
core
Grafh 3