Ibiza Light BIGPAR-16RGBW4A Manual De Instrucciones página 4

• The product is for decorative purposes only and not suitable as a household room illumination.
• If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manu-
facturer or his service agent or a similar qualified person in order to avoid a hazard.
• The light source of this luminaire is not replaceable. When it reaches the end of its life time, the whole unit
must be discarded.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall
remain readily operable.
FUSE REPLACEMENT
Locate and remove the unit's power cord. Once the cord has been removed located the fuse holder located in-
side the power socket. Insert a flat-head screw driver into the power socket and gently pry out the fuse holder.
Remove the bad fuse and replace with a new one.
Warning: If after replacing the fuse you continue to blow fuses, STOP using the unit. Contact customer support
for further instructions. Continuing to use the unit may cause serious damage.
INSTALLATION
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to
avoid vibration and slipping while operating. Always ensure that the structure to which you are attaching the
unit is secure and able to support a weight of 10 times of the unit's weight.
LED DISPLAY
MENU: Press to find an operation mode or to leave the current menu option.
UP: Press to scroll upwards through the list of options or set a higher value.
DOWN: Press to scroll downwards through the list of options or to set a lower value
ENTER: Press to activate a menu option or a selected value
DMX IN: Connect a 3-pin XLR connector from the DMX controller to this input
DMX OUT: Connect a 3-pin XLR connector from this output to the DMX input of another
DMX controlled unit
POWER IN: Connect the supplied mains lead to this input and the other end to an ap-
propriate wall outlet
POWER OUT: Connect a IEC power lead from this output to the POWER INPUT of the following BIGPAR. You can
connect up to 10 BIGPAR maximum.
MENU STRUCTURE
No. Display
1 A001-512:
2 Au01-15:
3 UF01-99:
4 FF01-99:
5 UC01-99:
6 FC01-99:
7 UE01-99:
8 FE01-99:
9 R000-255:
10 G000-255:
11 B000-255:
12 P000-255:
13 A000-255:
14 A000-255:
15 F000-255:
16
BLOF /bLON: "BLOF" means during silence, the light stays on. "bLON" means that during silence, the
17
4
MANUAL - BIGPAR-16RGBW4A/-4UV/-4WWCW
BIGPAR-16RGBW4A
Amber Color jump
Amber Color gradient
Amber Color pulse variable
Amber dimming
Amber dimming
Automatic mode: colour jump/gradient/pulse change
VOL1~VOL9 1-9 sensitivity adjustment
©Copyright LOTRONIC 2022
BIGPAR-16RGBW4UV
12 ch DMX mode
Fixed color selection
RGBW Color jump
UV Color jump
RGBW Color gradient
UV Color gradient
RGBW Color pulse variable
UV Color pulse variable
Red Manual dimming
Green Manual dimming
Blue Manual dimming
White dimming
UV dimming
UV dimming
Stroboscopic mode 1-20Hz
light will go off
MENU UP DOWN ENTER
DMX512
INPUT
DMX512
OUTPUT
BIGPAR-16RGBW4WWCW
WW/CW Color jump
WW/CW Color gradient
WW/CW Color pulse variable
WW/CW dimming
WW/CW dimming