Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Before using your beverage refrigerator:
• Remove the exterior and interior packaging.
• Before connecting the appliance to the power outlet, let it stand upright for approximately
2 hours. This will reduce the possibility of malfunction in the cooling system from handling
during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• Place your appliance on a floor that is strong enough to support the appliance when it is
fully loaded.
• To level your appliance, adjust the front legs at the bottom of the appliance.
To install the door handle:
For shipment, the door handle has been stored inside of the unit binding to the wood shelves.
To install the handle, the door gasket should be gently pulled back where it covers the screw
holes for the handle, then the handle should be attached by screwing into place with the two
screws which are packed in the box with this Instruction Manual and other spare parts.
To reverse the door swing:
As you received your beverage refrigerator, the door swings open at the left. If you wish to
reverse the swing so that the door opens from the right, it is most important to have at least
one other person to help. It is very dangerous to try to reverse the door swing by yourself,
without anybody's help the door might fall and the glass might be broken, which is terribly
dangerous.
(For the model B521F) Now, unscrew the upper door hinge while the second person holds the
door. Remove the upper hinge and carefully lift the door off the bottom hinge. Unscrew the
bottom hinge and install it on the left side of the unit. Flip the door around so that the handle
is on the right side and slip the door over the bottom hinge. Reattach the door by screwing the
top hinge into the holes provided on the upper left surface of the unit. Make adjustments as
necessary to be sure the door is aligned properly.
(For the model B422D) Unscrew the lower door hinge while the second person holds the door.
Remove the lower hinge and carefully lift the door off the upper hinge. Unscrew the upper hinge
and install it on the left side of the unit. Flip the door around so that the handle is on the right
side and slip the door over the upper hinge. Reattach the door by screwing the lower hinge into
the holes provided on the lower left surface of the unit. Make adjustments as necessary to be
sure the door is aligned properly.
10
Publicidad
