Descargar Imprimir esta página

HomeMatic HmIP-BDT-I Manual De Instalacion Y Uso página 36

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 63
Start-up
6.2
Installation overview
Homematic IP
Homematic IP
Dimming Actuator
Switch Module for
for Brand Switches
brand switches
6.3
Installation
To remove an existing switch, follow the instructions of the respec-
tive switch manufacturer.
You can use the dimming actuator (see fig. 3) in a dimming circuit:
To install the dimming actuator, please proceed as follows:
Switch off the circuit breaker for the power circuit (see figure 2).
Place a suitable adapter on the dimming actuator and screw it
tight using the enclosed screws (see figure 4). For further details
on installation, refer to the operating instructions for the adapter.
Connect the dimming actuator as shown in figure 3.
Loosen the screws of the flush-mounted box and screw it slightly
outwards.
Place the dimming actuator with the mounted adapter onto the
screws in the flush-mounted box and screw the screws back in
(see figures 5+6).
Place the frame of your switch series on the dimming actuator
(see figure 7).
Insert the rocker into the frame (see figure 8).
36
Suitable
Adapter
Suitable
adapter
Frame
(Example)
Frame
(example)
Rocker
(Example)
Rocker
(example)

Publicidad

loading