Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
Do the following preparation before beginning the assembly.
▸
Create sufficient space on a level and clean floor area.
▸
Lay the white protective sheet (
• Make sure that no foreign bodies appear on or under the protective sheet during assembly.
Note
• Some of the components (e.g. the halves of the long frame sides, cushion blocks, cover plates) are provided in multiples. Which these are, can be seen in the
illustrations. The work steps described will then have to be carried out multiple times.
INNER FRAME ASSEMBLY
▸
Take the frame pieces and other parts out of the carton and place them in the position shown in the illustration below
▸
Combine the two halves of the inner frame long side (
▸
Insert the frame connectors (
▸
Connect the inner frame short side (
tions with connector screws (
▸
Install the Vertical Beam (
) and fasten it with screws.
F
▸
Put the assembled inner frame aside and proceed to the next step.
) flat on the ground
I
and
A1
) into the ends of the inner frame short sides (
D
B
) with the attached frame connectors (
)
E
) using the longitudinal connector (
A2
) and secure the connections with connector screws
B
D
) into the ends of the inner frame long sides (
)
C
A1
/
A2
) and secure the connec-
Publicidad
