Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
4. Locate both holes at end of the ramp. Mark the
pin locations using a pen/pencil.
5. Remove the ramp and then, using a drill
and 5/16 bit, drill a hole approximately 2 inches
deep.
6. Now place the ramp back to the desired
location and drop clevis pins (AA) into
the holes to secure the ramp in that location.
Hardware Used
Clevis Pin
AA
4.
Locate both holes at end of the
ramp. Mark the pin locations using
a pen/pencil.
5.
Remove the ramp and then, using
a drill and 5/16 bit, drill a hole
approximately 2 inches deep.
6.
Now place the ramp back to the
desired location and drop clevis
pins (AA) into the holes to secure
the ramp in that location.
x 2
6
6
4
A
B
5
6
A
B
Publicidad
