Publicidad
Idiomas disponibles
Idiomas disponibles
release buttons and lift the system
outer foil upward to remove it. To
insert the new system outer foil,
press down until it snaps into place.
Replacing the inner blades (see
fig. 8)
Press the foi! frame release button
to pop open the foil frame. Pull the
foil frame vertically out of the upright
shaver. Remove the inner blade one
at a time by grasping it firmly at both
ends and pulling straight away from
the shaver. To insert the new inner
blades, hold the blade one at a time
at both ends and press downward
until it snaps into place.
ATTENTION:
The product you have purchased is
powered by a nickel cadmium bat-
tery which is recyclable. At the end
of it's useful life, under various state
and local laws, it is illegal to dispose
of this battery into your municipal
waste stream. Please call 1-800-8-
BATTERY for information on how to
recycle this battery.
E
How to remove the built-in
rechargeable battery
before disposal of the
shaver (see fig. 9)
The battery in this shaver is not
intended to be replaced. The proce-
dure described in fig. 9 is intended
onty for removal of proper disposal.
Discard shaver after the battery has
been removed.
WARNING:
Do not attempt to
replace the batteries for the pur-
pose of reusing the shaver. This
could result in the risk ot fire or
electric shock.
1. Remove the cap, outer foil frame,
inner blades and trimmer. (see
fig. 9A) (Trimmer must be pulled
away from main body using some
force.)
2. Remove the trimmer diving bar
"one two screws (a). (see fig.
9
3. Remove two screws (c) and bot-
tom cover (d). (see fig. 9C}
4, Pull the chassis out of the hous-
ing. (see fig. 9D)
5. Remove the batteries from the
chassis. (see fig. 9E)
Caution
Do not charge the shaver where the
temperature is below 0°C (32°F) or
above 40°C (104°F), where it will be
exposed to direct sunlight or a heat
source, or where there is a lot of
moisture.
Use only the included shaver charg-
ing adaptor RE3-62 to charge the
ES766 shaver. The supply cord of
the charging adaptor cannot be
replaced; if the cord is damaged, the
appliance should be discarded.
Dry the shaver completely before
setting it in the charging adaptor.
Keep the charging adaptor away
from water and handle it only with
dry hands. Do not use an extension
cord to connect the charging adap-
tor to an outlet.
Do not place any meta! objects like
coins and paper clips on the charg-
ing adaptor as they will become
Publicidad
