Publicidad
Idiomas disponibles
Idiomas disponibles
Systems IndicatorMonitor/Hour Meter
Brake
©
BATT.
42.01
///
HOURS
1/10 \\\
PTO / BLADE
PARKING
©
©
LCD
When the ignition key is rotated out of the STOP position but not
into the STARTposition, the systems indicator monitor displays
the battery's output, in volts, on its LCDfor approximately five
seconds, after which it displays an hour glass and the hours
of tractor operation. Once the tractor is started, the monitor
continually displays an hour glass and the hours of tractor
operation on its LCD.
NOTE; Hours of tractor operation are recorded any time the
ignition key is rotated out of the STOPposition, regardless of
whether the engine is started.
The Indicator Monitor will also remind the operator of
maintenance intervals for changing the engine oil. The LCD will
alternately flash the recorded hours, "CHG" and "OIL" for five
minutes, after every 50 hours of recorded operation elapse. The
maintenance interval lasts for two hours (from 50-52,100-102,
150-152, etc.). The LCDwill also flash as described above for five
minutes every time the tractor's engine has been started during
this maintenance interval. Before the interval expires, change
the engine oil as instructed in the Maintenance section of this
Operator's Manual.
If the Brake light illuminates
when attempting
to start the
tractor's
engine, depress the brake pedal.
PTO(Blade Engage)
If the PTO light illuminates
when attempting
to start the tractor's
engine, move PTO lever into the disengaged
(OFF) position.
0il
It is normal for the Oil light to illuminate while the engine is
cranking during start-up, but if it illuminate's during operation,
while the engine is running, stop the tractor immediately and
check the engine oil level as instructed in this Owner's Manual.
Battery
It is normal for the Battery light to illuminate
while the engine is
cranking
during
start-up,
but if it illuminate's
during
operation,
while the engine is running,
the battery
is in need of a charge
or the engine's
charging
system is not generating
sufficient
amperage.
Charge the battery
as instructed
in the Service
section
of this manual or have the charging
system checked by
your Cub Cadet dealer.
PTO / Blade EngageKnob
Activating
the PTO engages
power to
the cutting
deck or other (separately
available)
attachments.
Pull outward
on the PTO/Blade Engage knob to
activate
it, Push the PTO/Blade
Engage
knob inward to disengage
the power
to the cutting
deck or other (separately
available)
attachments.
NOTE:The
PTO/Blade
Engage knob
must be in the disengaged
(OFF)
position
when starting
the engine.
PTO
OFF
ON
SECTION 4
--
CONTROLS AND FEATURES
13
Publicidad
