Publicidad
Idiomas disponibles
Idiomas disponibles
Соковыжималка BOMANN AE 1915 CB Profi Cook
В интернет-магазине www.clatronic-shop.com.ua
General Safety Instructions
Read the operating instructions carefully before putting the
appliance into operation and keep the instructions including the
warranty, the receipt and, if possible, the box with the internal
packing. If you give this device to other people, please also pass
on the operating instructions.
•
The appliance is designed exclusively for private use
and for the envisaged purpose. This appliance is not fi t
for commercial use. Do not use it outdoors (except if it is
designed to be used outdoors). Keep it away from sources
of heat, direct sunlight, humidity (never dip it into any liquid)
and sharp edges. Do not use the appliance with wet hands.
If the appliance is humid or wet, unplug it immediately.
•
When cleaning or putting it away, switch off the appliance
and always pull out the plug from the socket (pull on the
plug, not the cable) if the appliance is not being used and
remove the attached accessories.
•
Do not operate the machine without supervision. If you
should leave the workplace, always switch the machine off
or remove the plug from the socket (pull the plug itself, not
the lead).
•
Check the appliance and the cable for damage on a regular
basis. Do not use the appliance if it is damaged.
•
Do not try to repair the appliance on your own. Always
contact an authorized technician. To avoid the exposure
to danger, always have a faulty cable be replaced only by
the manufacturer, by our customer service or by a qualifi ed
person and with a cable of the same type.
•
Use only original spare parts.
•
Pay careful attention to the following "Special Safety Instruc-
tions".
Children and Frail Individuals
•
In order to ensure your children's safety, please keep all
packaging (plastic bags, boxes, polystyrene etc.) out of their
reach.
Caution! Do not allow small children to play with the foil as
there is a danger of suffocation!
•
In order to protect children or frail individuals from the ha-
zards of electrical equipment, please ensure that this device
is only used under supervision. This device is not a toy. Do
not allow small children to play with it.
Symbols in these Instructions for Use
Important information for your safety is specially marked. It is
essential to comply with these instructions in order to avoid
accidents and prevent damage to the machine:
WARNING:
This warns you of dangers to your health and indicates
possible injury risks.
CAUTION:
This refers to possible hazards to the machine or other
objects.
24
05-AE 1915 CB 24
NOTE: This highlights tips and information.
Special Safety Instructions for this Machine
1. The machine should only be used under supervision!
2. Do not manipulate any of the safety switches!
3. Before removing any covers or accessories, switch the
device off and wait until the motor has stopped.
4. Please take care when handling the centrifuge sieve. It is
very sharp!
5. The machine may only be switched on when the stopper rod
is inserted.
6. Do not carry or lift the appliance during use. Always switch
it off fi rst and pull out the plug. Carry the appliance always
with both hands!
7. Clean the appliance only as described in „Cleaning".
WARNING:
Do not use the device if the rotating fi lter is damaged.
Overview of the Components
1 Tamper
2 Cover / Filling hole
3 Centrifuge sieve
4 Centrifuge housing
5 Drive wheel
6 Motor housing
7 Safety lock
8 Multiple contact switch
9 Pomace container
10 Safety switch
11 Spout
12 Rubber feet
Operation
1. Place the machine on a smooth, fl at and stable working
surface. Please place the centrifuge housing on the motor
block in such a way that the spout lies fl ush in the recess.
Place the centrifugal screen (3) in the centrifuge housing (4).
2. Place the cover in position and lock the safety catch. The
locking devices must engage in the recesses of the cover.
NOTE:
Your device is fi tted with a safety switch (10). This pre-
vents the motor from starting accidentally. Check that the
centrifuge fi lter and cover are correctly positioned.
3. Hook the pulp container (9) under the cover (2) such that it
is fl ush.
4. Please ensure that the multiple contact switch is set to „O".
5. Connect the machine to a properly installed power socket,
230 V, 50 Hz.
6. Place a suitable vessel under the spout (11) of the centrifuge
housing.
18.04.2007, 12:38:36 Uhr
Publicidad
