IMG STAGELINE LTR-102 Manual De Instrucciones página 10

GB
6. Change from XLR to
7. Change from balanced to unbalanced and vice versa.
4 Operation
1) Switch off all units before connecting them to the matchbox
LTR-102.
2) Connect the signal source (instrument, microphone, com-
puter, etc.) via the
INPUT. If both jacks are connected to a unit, the XLR jack
will be switched off. The connection between the signal
source and the matchbox must be as short as possible in
order to reduce interferences.
3) Connect the following unit (e.g. amplifier, mixer, effect unit,
etc.) via the
If both jacks are connected to a unit, the XLR jack will be
switched off.
4) Switch on all units which are connected. With the volume
at the amplifier reduced, operate the switches (2-4) of the
matchbox as follows.
5) Should humming occur, press the GND switch (4) and/or
RATIO (2) to eliminate resp. reduce the humming. The
RATIO switch (2) should always be depressed when using
long lines (more than 2 m). Thus, the line at the output (5
or 6) will be less sensitive to interferences.
6) Should a turn of phase occur during the complete signal
transmission, this can be compensated by pressing the
PHASE switch (3). Sometimes it is possible to achieve the
correct setting by listening to the bass.
10
1
/ " jack and vice versa.
4
1
/ " jack (1) or the XLR jack (8) to the
4
1
/ " jack (5) or the XLR jack (6) to the OUTPUT.
4