Connection And Operation - LD Systems LD MAUI11/W Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 62
SETUP, CONNECTION AND STARTUP:
TRANSPORT
The LD MAUI 11 PA System is very compact and easy to transport. The subwoofer must be placed on the rubber
feet before use. Please NEVER use the system while it is on a transport trolley! There is a danger of uncontrolled
movement of the entire system. This can lead to accidents and damage. The amplifier cooling elements are in
the back of the subwoofer. When the amplifier is in use, please maintain a minimum distance of 50 cm between
these cooling elements and other objects, walls, etc., to permit sufficient heat exchange.
Please make certain that the system and all connected source devices, mixers, CD players, etc. are properly
connected to one another and to the power mains. Use only undamaged cables with a sufficient cross-section
and only completely unrolled cable reels. Route the cables so as to avoid tripping hazards (gaffa tape). The unit
should never be positioned directly at an edge. Please also do not position the subwoofer on a table. It is advisa-
ble to always turn the system on last and off first in order to avoid loud popping sounds when the connected
devices are turned on and off.
SETUP
The LD MAUI 11 PA System consists of the following two components:
1
Subwoofer with integrated electronics for the 2 parts of the system.
2
The vertical array column with 8 x 3" speakers, the tweeter and a multipin connector on the bottom. Once
the subwoofer is positioned, the vertical array column is plugged onto the subwoofer. Two sturdy steel pins
help ensure that the multipin connectors of both speakers mate perfectly.

CONNECTION AND OPERATION

It is possible to set both the overall system volume as well as the volume of the subwoofer in relation to the
overall volume. The ultimate volume level is then adjusted via the source device. The connections permit both a
balanced and an unbalanced connection (XLR / jack 6.3 mm) to a source device.
The position of the connectors and control elements of the LD MAUI 11 are shown below.
6

Publicidad

Tabla de contenido
loading

Tabla de contenido