Publicidad
Idiomas disponibles
Idiomas disponibles
The drywall screwdriver has been developed to screw
drywall.
When operating the drywall screwdriver, you must consider
some use procedures:
▪ Do
not
apply
excessive
workpiece/object. If the speed drops abruptly, reduce
the pressure applied to the drywall screwdriver
immediately;
▪ Never put the machine down before the bit has
completely stopped;
▪ Wear hearing protection when using the screwdriver.
Exposure to noise can cause hearing loss;
▪ Work in such a way that the power cord always remains
behind the drywall screwdriver during operation;
▪ Switch off the drywall screwdriver immediately if any of
the following problems occur:
- Grease leakage through the ventilation slots;
- Damage on the housing;
- Damage on the "ON/OFF" switch;
- If you sense smoke or burning smell.
pressure
against
the
1. Before inserting the battery (9), make sure the "ON/OFF"
switch (5) is off positioned;
2. Place the screwdriver against the surface to be screwed
and press the "ON/OFF" switch;
3. Use the screwdriving depth stop (2) to set when the
screwdriver must stop;
4. To switch off the screwdriver, release the "ON/OFF"
switch trigger;
To operate the drywall screwdriver continuously:
5. Press the "ON/OFF" switch and simultaneously press the
switch lock-on button (4). Release the buttons and
operate the screwdriver with the "ON/OFF" switch locked;
6. To switch off the screwdriver, press the "ON/OFF" switch
and release it.
Do not select the direction of rotation while the screwdriver
is running. This could cause serious damage to the
screwdriver. Always check the direction of rotation before
starting operation.
1. Use the forward/reverse lever (3) to select the direction
of rotation of the shaft:
▪ With the lever on the left, the shaft turns clockwise;
▪ With the lever on the right, the shaft turns
counterclockwise.
Publicidad
