Publicidad
Idiomas disponibles
Idiomas disponibles
2. - PRODUCT HANDLING
Product handling refers to its use with the
CDC Ref. 5059. The steps to be taken to
install Modem Ref. 5836 with Ref. 5059 are
as follows:
a) Using command software and local con-
figuration, introduce the PIN (Personal
Identification Number) of the SIM Card in
the CDC Ref. 5059 (Further information
can be obtained from the CDC Manual).
b) Connect using an Ethernet cable (direct
connection) the external RJ45 Connector
of the GSM Modem and the RJ45
Modem Connector of the CDC.
c) Insert the desired operator SIM Card in
the user port.
NOTE:
For your ability to operate with the CDC
Ref. 5059, you must necessarily have a SIM
(Subscriber Identity Module) card with GSM
02.02 support services enabled by the ope-
rator, so that incoming calls to the
GSM/GPRS are DATA and NOT VOICE-
identified calls.
In some cases, the operator supplies
through SIM, one phone number for Voice
calls and another one for Data calls. this
must be borne in mind when establishing a
remote communication (call data number)
with control.
d) Bus-connect feed.
Check that the PWR LED on the Modem
lights up and that the STATUS LED lights
up and blinks as described in the pre-
vious item on LEDs.
NOTE:
The Televés GSM Modem supports phase 2
of the standard 3-Volt GSM11.14 – SIM.
The Ref. 5836 possesses and internal SIM
Card reader enabling the "hot-status" chan-
ge of SIMs. Therefore, the SIM Card may be
withdrawn and reinserted while the Modem
is still active.
NOTE:
It should be stressed that the interval
necessary between consecutive sessions
must be of 2 minutes, to guarantee that the
CDC is enabled to attend a new call.
17
Modem GSM
Publicidad
