Texi Black Turbo Manual Del Usuario página 25

Texi Black Turbo
TROUBLESHOOTING
PROBLEM
Water droplets come out
along with steam
The water level monitoring
system has activated de-
spite there is a sufficient
amount of water in the
tank
The steam generating time
is significantly extended
Fabric or the ironing board
gets wet during ironing
The pressure gauge shows
pressure inside the appli-
ance, but steam does not
leave the head
The appliance does not
work
Weak steam flow
Water visible outside of the
water tank
Water visible on steam
head
Crack on holder
Deformed water tank
The telescopic mast collaps-
es or falls apart
The appliance's power
switch is lit up but the
appliance does not produce
steam
DISPOSAL
According to Directive 2012/19/EU on waste electrical and electronic equipment, this product should
not be treated as household or municipal waste.
This appliance is subject to Directive 2011/65/EU on the restriction of the use of certain hazardous
substances in electrical and electronic equipment. It should be transferred to the appropriate collec-
tion point handling recycling of electrical and electronic equipment.
Ensuring proper disposal may prevent potential adverse consequences to the environment and human health,
which may be caused by improper handling of waste of this type. Appropriate recycling of materials helps to
protect natural resources. Improper disposal of the product by the user may lead to administrative sanctions.
CAUSE
The process of heating the
steam head has not ended
Sediments have accumulated in
the basin under the water tank
Sediments have accumulated in
the steam boiler
Too much steam
The steam hose has not been
installed properly
The appliance is not connected
to the power grid
Circuit failure
Power switch failure
Grid voltage is below rated
voltage
Sediments are blocking the
steam channel
Damaged water tank
Damaged steam head
Damaged holder
Improperly fabricated holder
Water in the tank is too hot
Improper preparation
The steam generator is not
working
The relay is not working
No water in the water tank
www.TEXI.info
SOLUTION
Let the head heat up for 90 seconds
Clean the basin and metal sensor
Switch off the appliance and let it cool
down for 2 hours. Open the drain valve at
the bottom of the appliance to clean the
boiler. Shake the appliance lightly as it is
being emptied. Repeat the filling and emp-
tying procedure several times.
Soften the material with steam, then iron it
without steam
Install the steam hose properly.
Deliver the appliance to an authorized
service center or qualified service techni-
cian for repair or regeneration.
Check power supply.
Clean the boiler from sediments.
Replace water tank
Replace the steam head.
Check the cleaning switch of the steam
head
Replace holder
Replace water tank.
Contact an authorized service.
Assemble the mast correctly. To lock a
segment, turn it clockwise.
Deliver the appliance to an authorized
service or qualified service technician for
repair or regeneration.
Replenish water
25