Publicidad
Idiomas disponibles
Idiomas disponibles
EN
•
Do not rush. Be sure to keep a safe position and keep your balance at any time. This will allow you
to better control the electric tool in unexpected situations.
•
The use of the machine requires specific training and instructions. Any operator is obliged to justify
training to be able to manipulate the device.
ELECTRICAL SAFETY RULES
•
The splitting operation by the machine is intended to be activated by one person. Only one operator
should activate the splitting operation.
•
It must be that the electrical tool sheets are adapted to the base. Never modify the sheet in any way.
Do not use adapters with earth connection tools. Unclear sheets and suitable bases will reduce the
risk of electric shock.
•
Do not mistreat the cord. Never use the cord to wear, pull or disconnect the tool. Maintain the cord
away from heat, lubricant, edges or moving parts. When using an outside tool, use an extension
adapted to external use. If the use of a tool in a damp location is inevitable, using a power supply by
a residual differential current device (RCD).
•
The power cable cannot be replaced. If the cable is damaged, the device should be put to the scrap.
SPECIFIC RULES FLOW BUCH
•
Read all the instructions on the logging and in the manual carefully before trying to go up and ope-
rate the device.
•
Keep this manual in a safe place for subsequent use and consult it regularly.
•
Do not use this electric garden tool for any other task to which it is not intended to be used. Do not
force the cutting / cutting roller.
•
Stay vigilant: do not use the logging of the logs when you are tired. Be very careful about what you
do.
•
Never leave the device without surveillance. Do not leave the machine unattended when it is in use.
•
Make sure that the logs to be split are the minimum or maximum recommended diameter.
•
Make sure that the logs to be split are the minimum or maximum recommended length.
•
Make sure the work area is without obstacles.
•
The device should be supplied only under the low voltage of safety corresponding to the marking
of the device.
•
The socket must be connected to a portable residual current device (PRCD) if no maximum 0.03 A
residual current device (RCD) is provided in the electrical circuit.
•
Do not try to make any adjustment when the engine is in operation.
•
Before any use, make sure the good condition of the splitting corner.
•
It is necessary to wear protective glasses when you use the machine with dry wood. Do not wear
jewelry or too large clothes, so that they do not get stuck in the branches being caught. Wearing
gloves and safety shoes is recommended.
•
Do not insure your hands or feet in the cutting area. Contact with the cutting roll can cause serious
injuries including the amputation of the fingers or hands.
•
The machine should not be used by children.
•
Avoid risky situations. Do not use the logging in the rain or to cut wet wood.
•
Cut the engine when moving the logging shots on its wheels and make sure you never touch the
floor with your feet.
•
If the machine starts to vibrate abnormal, stop the engine and search for the cause immediately.
Vibrations are generally caused by a blockage, a knot, logs of irregular forms or a more serious
problem (damaged blades).
•
Be sure to insert the logs adequately to avoid any risk of injury.
•
Disconnect the socket in the event of non-use of the machine or in the absence of an operator.
•
It is imperative to start the logging in an airy, plan and cleared space.
20
21/11/2022
Publicidad
