Publicidad
Idiomas disponibles
Idiomas disponibles
•
The soil should not be frozen.
•
Start the device on a clear flat surface, never tilt the machine for use.
•
Be sure to maintain your lateller well. Keep blades for better yield.
•
If the blade strikes a foreign object, follow these steps:
- Stop the machine by cutting the power supply, wait until the blades stop turning
•
Completely then disconnect the socket.
- Make carefully check any possible damage to the machine.
- Have it repaired or replaced the blades in case they are damaged in any way.
•
Repair any damage before restarting the logging of the logs and resuming work.
•
Use suitable tools to have the blades repaired and disassemble the device.
•
Do not use the electric machine in the rain or in too wet places.
•
Disconnect the power outlet before any repair, cleaning or momentary absence of the work area.
•
Before starting the machine Replace damaged or illegible labels.
•
Before starting to check that the machine is empty.
•
Before starting to check that the oil level is sufficient.
•
Before starting control the pipes, hydraulic pipes and stop devices.
•
Keep the face and body remotely from the opening of the power supply.
•
Keep the balance permanently and a safe step. Do not go too far. During the introduction of material
in the machine, never stand at a higher level than that of the machine base.
•
Do not transport this machine as long as the power source is underway.
•
Do not tip the machine when the engine works.
•
Make sure all screws are tight and blocked.
•
Never try to operate manually.
•
Remove all the deposits from the machine using a brush.
•
Always clean the machine after use. Clean the plastic body and the plastic parts with soap and a
damp cloth. Do not use aggressive products or solvents for cleaning.
•
Unplug the machine according to the instructions in the paragraph «CLEANING» before «Always
clean after each use.
•
Never clean the logging with a jet of water. Make sure you don't put water in the machine. .
•
Use only the recommended accessories for this logging.
•
Let the logging shield cool before storage.
•
Scrupulously read safety rules and user manual before using your multifunction tool.
21/11/2022
EN
21
Publicidad
