Home Decorators Barkridge Serie Guía De Uso Y Cuidado página 6

Operation (continued)
1
Powering the Log Set Heater
□ Press this button into the "I" position for main power of the
unit.
3
Heater Button
□ Press the Heater button to turn on or turn off the heater.
□ Each time the heater is turned on, it should stay on for at
least one minute.
□ When the ambient temperature is higher than the set
temperature, heat will turn off automatically.
2
Flame Button
□ This button controls the brightness of the flame effect with
settings at High, Medium and Low.
□ When the log set is first turned on, the flame will come on at
the highest setting.
□ Each time the Flame button is pressed, the brightness
decreases. The only way to turn off the flame effect
completely is to turn off the Power switch.
4
Adjustable Thermal Control
□ To adjust the temperature to your individual requirements,
turn the thermostat dial to the right (clockwise) to increase
the temperature and to the left to decrease the temperature.
□ This thermostat control dial can only be used while the
power switch is in "I" position and the heater needs to be
turned on.
□ When the heater reaches the desired temperature, the
heat will turn off. When the temperature dropps below the
selected temperature, heat will restart again.
6