MAINLINE ML17CP2 Instalación

Inlet Sizes Available
Before installing make certain that the sillcock connector (inlet) size
matches existing water supply lines, and that through-the-wall length is
adequate.
Installation / Installation / Instalación
How to Install
1. Bore a hole through the foundation wall or the floor joist band according to inlet diameter and insert the sillcock from the
outside.
2. Position the sillcock so that the outside spout is pointed down. To check spout position from inside the building, notice that
when the mark (TOP) on the inside connection (inlet) points up, the outside spout is down (see illustration below).
3. Slip the plastic bevel wedge between flange sillcock and the wall by inserting the thin part first (see illustration below) to form
the downward angle, so water will drain properly. Draining is necessary for frost-proof performance.
4. If the inside connection (inlet) is to be sweated (soldered), remove stem before applying heat.
5. Secure sillcock flange with two #8 or #10 wood screws or with appropriate masonry hardware.
Typical
Installation
Remove stem while
Remove stem while
sweating (soldering)
sweating (soldering)
connection
connection
Packing nut
Packing nut
This end slightly lower
This end slightly lower
IMPORTANT – TO ASSURE DRAINAGE:
Turn sillcock handle to closed position and detach hose from spout during freezing weather. If hose is left attached, the frost-
proof sillcock cannot drain properly and trapped water may freeze and damage sillcock.
The frost-proof sillcock assures no freeze operation because the valve mechanism shuts off water inside the building, where it
is heated. If building will be unheated for any length of time, then all water lines should be drained and plumbing fixtures
winterized.
NOTE: The packing nut, located behind the handle, has been factory adjusted. If leakage should occur after installation or use,
the packing nut can be tightened to stop the leak (see illustration above).
1/2" MIP
1/2" MIP &
1/2" SWEAT
1/2" Sweat
1/2" PEX
1/2" PEX
Beveled wedge
Lead Free* Anti-Siphon
Frost Free Sillcock
Model# Length
ML17CP2
ML17CP4
ML17CP6
ML17CP8
ML17CP10
ML17CP12
ML17CP14
Wall thickness
5°Angle
Model#
2" ML17PX2
ML17PX4
4"
6" ML17PX6
ML17PX8
8"
ML17PX10
10"
ML17PX12
12"
14"
"TOP"
Mark
Mark
Inlet
Inlet
Length
2"
4"
6"
8"
10"
12"