BOMANN MS 364 CB Instrucciones De Servicio página 22

All manuals and user guides at all-guides.com
Foaming milk
• Attach attachment "B".
• Fill between 100ml and 175ml cold milk into the jug.
Caution:
Observe the filling mark, the milk will otherwise foam over.
Note:
• For optimum results use milk with 3.5% fat content and
fill in 175ml.
• Milk with 1.5% fat content and soy milk or lactose-free
milk does not froth as well.
• Attach the lid to the appliance. The slot in the lid must sit
on the handle.
Warm up the milk
• Attach attachment "A".
• Fill between 100ml and 350ml cold milk into the jug.
Note: Observe the filling mark.
• Put the cover on. The slot in the lid must sit on the handle.
Switch on
• Place the can onto the base.
• Press the switch on button. The lamp in the switch lights
up. The milk is whipped and heated up.
Note:
► The appliance can only be operated with attached jug.
► The switch is only for turning on. The process runs
automatically and ends with the temperature reaching
approx. 80°C (after approx. 90 seconds).
Caution:
Do not press the switch continuously.
• You can fill the milk foam into a cup when the control light
goes out.
Interrupting operation
Lift the can from the base, if you would like to interrupt opera-
tion.
Further Tips:
► After using the milk frother for warming up liquids it
takes approx. 9 minutes for the appliance to cool down
again. During this period the pilot light inside the switch
flashes red.
► You can decrease this period by filling the jug with some
cold liquid.
Cleaning
Warning:
► Always pull the power supply plug before cleaning.
► Allow the appliance to cool down.
22
Caution:
► Do not use a wire brush or other abrasive items.
► Never use sharp or scouring cleaning materials.
Base and can from outside
Warning:
Never immerse the base and the can in water for cleaning.
It could result in an electric shock or fire.
Clean the outside of the base and can with a dry cloth, with-
out additives.
Jug inside and attachment
• Pull the attachment off the shaft.
• Only rinse the parts by hand with a soft cloth.
• Use clear water and a detergent.
• Clean tough stains with a cleaning brush.
• Rinse with clean water.
Troubleshooting
Malfunction Cause
Possible
The appliance - Is the appliance
does not work/ switched on?
the motor does - Is the mains socket
not turn defective?
The milk does - Is the frothing
not foam attachment "B"
properly attached?
- Is the attachment
blocked?
- Is there too little
milk in the can?
The pilot light The appliance is still
inside the switch too hot
flashes red.
Specifications
Model:......................................................................MS 364 CB
Power supply:.................................................. 220-240V, 50Hz
Power consumption: ........................................................550W
Protection class: ....................................................................... I
Net weight: .................................................................... 0.96 kg
Subject to change without prior notice!
This device complies with all current CE directives, such as
electromagnetic compatibility and low voltage directive and is
manufactured according to the latest safety regulations.
Remedy
- Try a different
socket
- Check the at-
tachment
- There should
be between 100
and 175ml in
thecan
Wait until the ap-
pliance has cooled
down.