Klein Tools SMART SENSE AESEB1S Manual De Instrucciones página 13

TURNING EARBUDS ON/OFF
ON: If the earbuds are inside the charging case, opening the Charging Case
Cover 5 , will automatically power on the earbuds. If the earbuds are not
inside the case, touch and hold the Capacitive Touch Area 1 on either
earbud for 1.5 seconds.
OFF: Placing both earbuds into the charging case and closing the Charging
Case Cover 5 will automatically power off the earbuds. Alternatively, touch
and hold the Capacitive Touch Area 1 on either earbud for 5 seconds.
PAIRING
After successfully powering on, the earbuds will automatically enter
Bluetooth pairing mode. "Pairing" voice prompt will be heard and the
®
Earbud LEDs 2 will alternate between flashing Red and Blue every
0.5 seconds. To pair with your device:
1. Ensure that Bluetooth is enabled on your device and it has discovered
"Klein SMART SENSE Buds" in the pairing list.
2. Select "Klein SMART SENSE Buds" and upon successful connection,
"Connected" voice prompt will be heard, and the Earbud LEDs 2 will
turn solid blue for three seconds, then turn off.
NOTES: 1) In the event auto pairing fails, power the earbuds off and on again.
2) The earbuds will automatically attempt to connect to the last paired wireless
device when turned on, but are ready to pair with any compatible device within
two minutes of powering on if the last paired device is not detected.
AUTO POWER-OFF
If no Bluetooth device is connected and situational awareness is off, the
earbuds will automatically power off after 10 minutes.
OPERATING INSTRUCTIONS
13