Fenton RP162LED Manual De Instrucciones página 3

UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging. If the device has been exposed to
drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water might
damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the mains
voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The unit must
also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
OVERVIEW
1. Tone arm lever
Use to raise/lower the tone arm.
2. Autostop switch ON/OFF
This switch turns auto stop on or off. When the automatic stop is enabled, the platform will start rotating as soon as the tone
arm is placed over the record and will stop rotating when it has reached the end of the record. Some vinyl records stop
before the end or do not stop when the end is reached. In this case set Auto-stop to OFF.
3. Headphone output
3.5mm headphone output jack.
4. 33 / 45 / 78 RPM switch
Use to adjust the RPM of the turntable platter.
5. Pitch control
Rotate to control/fine tune the pitch (turntable speed).
6. Mode
Rotate to change modes (USB, AUX, Phono, BT streaming).
7. LED indicator
8. On/off and volume control
Rotate to turn the device on/off and to adjust the volume level.
9. Lighting on/off / color change
Press and hold to turn LED lighting on/off. Press to change color.
10. Lighting mode
Press and hold to initiate fading animation. The colors will fade and change smoothly.
Press to initiate the LED lighting to follow the beat.
11. Stylus cartridge
Cartridge containing the stylus/needle.
12. Platter
13. 45RPM adapter
This adapter allows you to play 45RPM records.
14. Line output
RCA connector line output to connect external speakers (not included).
15. AUX input
3.5 mm auxiliary input jack.
16. DC 5V IN
5V power socket for connecting the supplied power adapter.
17. USB port
3