•
Be careful when you go near hidden corners and
objects that prevent a clear view.
Work safety
WARNING: Read the warning instructions
that follow before you use the product.
•
Use this product to cut grass lawns only. It is not
permitted to use it for other tasks.
•
Use personal protective equipment. See
protective equipment on page 7 .
•
Never start the engine in a closed space or near
flammable material. The exhaust fumes from the
engine are hot and can contain sparks which can
start a fire.
•
Do not operate the product unless the blade and all
covers are attached correctly. An incorrectly
attached blade can come loose and cause personal
injury.
•
Make sure that the blade does not hit objects such
as stones and roots. This can do damage to the
blade and bend the engine shaft. A bent axle causes
heavy vibration and a very high risk that the blade
becomes loose.
•
If the blade hits an object or if vibrations occur, stop
the product immediately. Disconnect the ignition
cable from the spark plug. Examine the product for
damages. Repair damages or let an authorised
service agent do the repair.
•
Never attach the engine brake handle permanently
to the handle when the engine is started.
•
Put the product on a stable, flat surface and start it.
Make sure that the blade does not hit the ground or
other objects.
•
Always stay behind the product when you operate it.
•
Let all the wheels stay on the ground and keep 2
hands on the handle when you operate the product.
Keep your hands and feet away from the rotating
blades.
•
Do not tilt the product when the engine is started.
•
Be careful when you pull the product rearward.
•
Never lift up the product when the engine is started.
If you must lift the product, first stop the engine and
disconnect the ignition cable from the spark plug.
•
Do not walk rearward when you operate the product.
•
Stop the engine when you move across areas
without grass, for example paths made of gravel,
stone and asphalt.
•
Do not run with the product when the engine is
started. Always walk when you operate the product.
•
Stop the engine before you change the cutting
height. Never make adjustments with the engine
started.
•
Never let the product stay out of view with the engine
started. Stop the engine and make sure that the
cutting equipment does not rotate.
287 - 004 - 21.11.2017
Safety instructions for operation
Personal protective equipment
•
Personal protective equipment cannot fully prevent
injury but it decreases the degree of injury if an
accident does occur. Let your dealer help you select
Personal
the right equipment.
•
Use heavy-duty slip-resistant boots or shoes. Do not
use open shoes or go with bare feet.
•
Use heavy, long pants.
•
Use protective gloves when necessary, for example
when you attach, examine or clean the cutting
equipment.
Safety devices on the product
•
Do not use a product with defective safety devices.
•
Do a check of the safety devices regularly. If the
safety devices are defective, speak to your
Husqvarna service agent.
Cutting cover
•
Examine the cutting cover to make sure that there
are no damages such as cracks.
Battery (LB 246PI)
The battery gives power to the electrical start and is a
safety device that prevents accidental start. Remove the
battery when you do not operate the product and when
you let it stay out of view.
Engine brake handle
The engine brake handle stops the engine. When the
engine brake handle is released, the engine stops.
To do an inspection of the engine brake, start the engine
and then release the engine brake handle. If the engine
does not stop in 3 seconds, let an approved Husqvarna
service agent adjust the engine brake.
(Fig. 19 )
Start inhibitor
On model LB 246PI the engine brake handle is also
used as a start bar for the starter motor. Do a check of
WARNING: Read the warning instructions
that follow before you use the product.
WARNING: Read the warning instructions
that follow before you use the product.
WARNING: A defective battery decreases
the safety of the product. Always use a
battery approved by the manufacturer.
7