Publicidad
Idiomas disponibles
Idiomas disponibles
[] Basic Connection
Thissection describes h owtoconnect t he unitto an antenna,cable/satellite b0x,etc.
Note:
• Besure your antenna or other device is connected properly before plugging in the power cord.
[Antenna
Cable
Connection]
When connecting
the unit to an antenna
or cable TV company
(without
cable/satellite
box)
Connect
the RF coaxial cable on your home outlet
to the antenna
input jack of this unit.
e.g.)
VHF / UHF'-_
rear of this unit
antenna
RF coaxial
cable
cableTV
company
_Once connections
are completed,
turn on the unit and begin initial setup.
Channel scanning
is necessary for the unit to memorize
all available
channels
in your area.
(Refer to"Initial
Setup"on
page 11.)
Note:
•For your safety and to avoid damage to device, please unplug the RFcoaxial cable from the antenna inputjack before moving the unit.
•If you use a.nantenna to receive analog TV,it should also work for DTV reception. Outdoor or attic antennas will be more effective than
settop
versions,
• Toeasily switch your reception source between antenna and cable, install an antenna selector.
•If you connect to the cable system directly, contact the CATVinstaller.
[Connection
to Cable
Box or Satellite
Box]
Connect
the RF coaxial cable on your home outlet
to the input jack of the cable/satellite
box.
Use another
RF coaxial cable to connect
the antenna
input jack of the unit to the output
jack of the cable/satellite
box.
e.g.)
satellite
dish
cable/satellite
box
i
ANT. IN
RF OUT
m m
cable TV
_F
coaxial cable
RF coaxial cable
company
rear of this unit
_Required cables and connecting
methods differ depending
on the cable/satellite
box.
For more information,
please contact your cable/satellite
provider.
iiii!
iiiiii!i
i ii!!_!i
EN
Publicidad
