Publicidad
Assembly instructions
Instructions d'assemblage
Instrucciones de ensamblaje
1. Attach the back cushion (B) to the seat cushion (A) by sliding the receivers into the mechanism
posts located on the seat cushion (A). From the front of the recliner, press down on both sides of
the back cushion (B) to firmly secure. The back cushion (B) and seat cushion (A) will automatically
lock into place.
2. Connect the connector between the back cushion (B) to the bottom of the seat cushion (A). Pull
the back flap down tightly and attach the back flap to the bottom of seat cushion (A). Then, one
end of the power transformer and cord (C) is connected to the seat cushion (A), and the other end
is connected to the socket-outlet (110V-240V) after removing the plastic cap from the plug. When
the power switch is pressed to the "—", it means it is on, and when it is pressed to the "O", it
means it is off.
NOTE: The socket-outlet shall be installed near the equipment and shall be easily accessible.
3. While seated in the recliner, enjoy the glide feature which allows you to gently glide forward and
backward.
4. While seated, press the "Open for recliner" control button on the right arm to make the back
cushion recline so it will move backwards. Press the "Open for headrest" control button on the
right arm to adjust headrest. To return the back cushion and pillow to your desired position, press
the "Close for recliner" and "Close for headrest" control button. You can also press the "Reset"-
control button to get it back to original position. The electric mechanism can provide you with the
most appropriate angle to make you relax. Please remove and put away power cord when it is not
in use.
4
Publicidad
