Publicidad
Idiomas disponibles
Idiomas disponibles
Steam ironing
1. Fill the water tank following the instructions.
2. Plug in the iron.
3. Position the iron vertically and turn the temperature control knob to the steam position. When steam
ironing, the appliance must be set to the maximum temperature, otherwise, the water will leak and drip
from the soleplate.
4. Preheat the iron until the indicator light goes out. The light will turn off when the iron reaches the indicated
temperature.
5. Turn the temperature control knob to the required setting for each type of fabric.
You may start steam ironing.
Spray Function
Before using the spray feature, check the fabric label for ironing instructions; some fabrics may become
stained with moisture.
The spray feature is particularly helpful for removing stubborn wrinkles and where extra dampening is
needed. You can use the spray with both steam and dry ironing. Simply press the Spray button whenever
you need it.
Burst of steam function
This feature provides additional steam for removing stubborn wrinkles. You can use the burst of steam with
both steam and dry ironing.
Press the Burst of Steam button to release a blast of steam. You might need to press the button several
times to activate the system. Wait a few seconds to allow the steam to penetrate the fabric before pressing
the button again.
Note: For optimum steam quality, do not apply more than three successive bursts.
Anti-Scale Function
You're iron is equipped with an integral anti-scale system located inside the water tank to eliminate
impurities from the water and to reduce the problems connected with lime scale build-up.
To prolong the working life of this system, please, follow these steps occasionally:
1. Unplug the iron and allow it to cool down.
2. Fill the cup provided with your iron to the 3/4 mark. Add 1 tsp. of salt and pour this solution into the
water tank.
3. Let the solution sit in the water tank for 15 minutes, gently shaking the iron occasionally. Then empty it
and repeat this step a second time.
4. Fill the tank with clean water to rinse it and empty it.
Anti-drip function
The principle of automatic selection of the steam according to the fabric selected reduces the steam flow at
lower temperatures and avoids water dripping from your iron onto the fabric.
Auto-Stop safety feature
The electronic system cuts off the electric power and the Auto-Stop warning light flashes if the iron is left
vertically on its heel for more than 8 minutes, or in a horizontal position for more than 30 seconds, for your
security.
To indicate that the iron has been switched off, the auto-stop indicator light will start blinking. To restart the
iron, just move it gently until the blue auto-stop pilot stops flashing. The blue temperature pilot will light up.
E NGL I SH
8
Publicidad
