Maintenance; Replace The Guard; Technical Data - GreenWorks AG24L00 Manual Del Operador

EN
wheel is 6,500 r/min. or more. The grinding wheel is correct
for grinding welds, preparing surfaces to be welded, grinding
structural steel, and grinding stainless steel.
Do not use the machine without the guard. Use the machine
without guard will cause injury to the operator.
Make sure all work in a vise or clamp to a workbench.
1. Use two hands to hold the machine in front and away
from you and the workpices.
2. Start the grinder and let the engine and grinding wheel
increase to full speed.
3. Lower the grinder until the grinding wheel touches the
workpiece.
4. Keep the machine tilted at an angle from 5° to 15° and
move at a stable speed.
5. Use sufficient pressure to keep the machine stable.
6. Lift the machine away from the workpiece before you
stop the machine.
To prevent loss of control and injury,operate the machine
with two hands and keep one hand on the auxiliary handle.
If you put the machine in one point too long or hold the
machine at too sharp an angle, it will make grooves in the
workpiece.
Heavy pressure decreases the speed and put a strain on the
engine. The weight of the machine is sufficient for most
grinding works. Use light pressure when you grind jagged
edges or loose bolts where there is the possible to stop the
machine on the metal edge.
8

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
CAUTION
NOTE
WARNING
NOTE
NOTE
CAUTION
CAUTION
English
Remove the battery pack from the machine before
maintenance.
8.1

REPLACE THE GUARD

Do not change or loosen guard screw. Failure to follow this
warning can make the guard to become loose during
operation and cause injury.
After extended use, you must replace the guard. If you fall the
machine and cause damage the guard. It is also necessary for
you to replace the guard.
To prevent loss of control and possible injury, operate the
machine with two hands and keep one hand on the auxiliary
handle.
• Remove the battery pack from the machine.
• Push the spindle lock.
• Use a wrench to loosen and remove clamp nut.
• Remove grinding wheel and disc flange.
• Pull the guard clasp to unlock the guard.
• Remove the guard from the groove in the housing.
• Put the new guard on the shoulder of the bearing cap.
• Adjust the guard to the correct position.
Make sure you install the ridge on the guard in the groove
on the bearing cap.
• Install disc flange, grinding wheel, and clamp nut.
• Tighten the clamp nut.
9

TECHNICAL DATA

Voltage
No Load Speed
Shaft
Disc Biameter
Weight (Without Battery)
Battery Model
Charger Model
The recommended ambient temperature range:
Item
Appliance storage tempera-
ture range
8
WARNING
WARNING
WARNING
NOTE
24 V
10500 RPM
5/8" (16 mm)
4 1/2" (115 mm)
3.54 lbs. (1.6 kg)
BAG711 and other BAG ser-
ies
29862 / 29972
Temperature
32°F (0°C) - 158°F (70°C)