Publicidad
Idiomas disponibles
Idiomas disponibles
Window Requirements
NOTE: All supporting parts should be secured to firm wood, masonry, or metal.
1. This unit is designed for installation in standard double hung windows with actual opening widths of
22" to 36" The upper and lower sash must open sufficiently to allow a clear vertical opening of 13"
from the bottom of the sash to the window stool.
2.If storm window presents interference, fasten a 2" wide woed strip to the inner window sill across
the fulll width of the sill. The wood strip should be thick enough to raise the height of the window sill
that the, unit can be installed without interference by the storm win_w
frame.
See Fig. 5-2. The top of the wood strip should be approximately si4"higher than the storm window
frame (STORM WINDOW FRAM E) or wood strip (OUTDOORS) to help condensation to drain
properly to the outside.
3. Install a second wood strip (approximately 6" long by 11/_z,, wide and same thickness as first strip) in
the center of the outer sill flush against the bah off the inner sill. This will raise the L bracket as
shown Fig. 5-2
4. if the distance beh,¢een STORM WINDOW FRAME and WOOD STRIP MOUNTED ON TOP OF
INNER SILL is more than 1'*,two of wood strips are not necessa@.
iNNER
WOOD STRIP MOUNTED
1" MAX,
Fig. _1
Fig. _2
HARDWARE ]
TYPE A: 1lEA
TYPE B: 5EA
TYPE C: 3EA
.....
(SHORTSCREW)
(WOOD SCREW)
......
(L BRACKET)
TYPE D: lEA
(SEAL STRIP)
(Adhesive backed)
TYPE E: lEA
(SASH SEAL)
(Notadhesivebacked)
E
E
TYPE F: 2EA
(GUIDE PANEL)
TYPE G: 1EA
(SUPPORT BRACKET)
Publicidad
