Publicidad
Idiomas disponibles
Idiomas disponibles
EN. USER MANUAL
1. WARNINGS AND PERSONAL SAFETY
SAFETY INSTRUCTIONS
Read the given instructions carefully before using the product.
CAUTION: Failure to follow the instructions and safety precautions will damage the unit or cause
injury to users or nearby persons.
• Read the instruction manual and follow the directions.
• Do not allow children to handle this equipment.
• Do not position the equipment too close to the pool. Install it at an adequate safe distance.
• Do not use any petroleum-based lubricants. Petroleum damages the product's plastic
components.
IMPORTANT!
This equipment is not intended for use by untrained persons, children, persons with restricted
physical, sensory or mental ability, or with limited experience and limited knowledge unless they
are supervised by someone responsible for their safety, or receive instruction regarding the safe
use of the equipment.
2. ASSEMBLY INSTRUCTIONS
See image 1
1. Unfasten the screw caps from the inlet and outlet.
2. P ut the O ring on both connectors and attach these firmly to the inlet and outlet. Fasten the
screw caps again to the inlet and outlet firmly.
3. A ttach the hose to the connector, fix the hose tightly with hose clamps using Phillips screwdriver.
4. Turn the aluminium supporting poles to the vertical position, and pull out the lower part of
poles to the appropriate length. Note: It is very easy to pull out the lower part. Do not use
force. Hold the upper part and twist the lower part to clockwise several times until the lower
part and upper part are fixed tightly.
5. Remove the protective covering on the upper side of the collector.
Connecting multiple collectors:
If you would like to increase the heating capacity, you can connect several collectors together.
We recommend connecting a maximum of 2 collectors, depending on the power of your filter
unit.
3. OPERATION GUIDE
3.1 Initial Use
Once the solar collector is assembled, and the hoses are connected to the filter pump and
the pool, open the water supply. Ensure that water is flowing through the hose. Then turn
on the filter system. Air bubbles will rise from the inlet nozzle in the pool. This happens as the
air is expelled from the solar collector. If this continues for more than 2-3 minutes, check the
tightness of the connections in your system.
PLEASE NOTE: Cover your pool overnight to avoid loss of heat.
3.2 Usage
Once the equipment is installed, it is connected between your filter system and your pool
using the two hose connectors. The connector hose pushes the cold water from your filter
unit into the solar chambers of your solar collector. Here it is heated by the sun's energy and
then fed to the second connector hose towards the pool.
See image 2
(A) = Feed from the filter unit to the solar collector
(B) = Feed from the solar collector to the swimming pool inlet nozzles
See image 3
Water heating depends on the following factors: Flow rate and the amount of sunshine.
S olar heating only functions efficiently in the sunlight. It can also remain connected to the
p ump in poor weather as this only causes a slight loss of pressure in the pump.
3.3 Tools And Accessories Required
These tools are required for assembly.
NOTE: They are not included in your set:
• Phillips screwdriver
• Flathead screwdriver
14
Publicidad
