Horizon Global 118884 Instrucciones De Instalación página 3

Always wear SAFETY GLASSES
when installing wiring harness
1. Open the rear hatch. On the driver's and passenger's side , using a trim panel tool, Phillips screwdriver, or 10mm socket remove the plastic
threshold cover, cargo trays, and the side panel exposing the vehicle's taillight wiring harness. Be careful not to break mounting tabs.
2. On the driver and passenger sides of the vehicle, locate the matching vehicle's taillight wiring harness connectors to the T-One® T-Connector
mating ends. Separate this connector, being careful not to break the locking tabs. All connector surfaces should be clean and free of dirt.
3. On the driver's side, insert the T-One® Connector end containing the
yellow wire in between the vehicle and taillight connector. All
connector's surfaces should be clean and free of dirt. Be careful not to
break any locking tabs.
©2023 Horizon Global™ Corp
Installation Instructions
PART NUMBER: 118884
4. On the driver's side, determine a suitable mounting point. Mount
Note: Clean flat mount surface area using a 50-50 mixture of rubbing
alcohol and water to mount lighting module black box.
the T-One® Connector black box using the double-sided tape
provided.
Sheet 3 of 18 118884-NP 3/24/2023 Rev. X1