JUISSEN SLOW JUICER Manual De Usuario página 13

7
9 10
6
Main components:
1. Hopper
2. Squeezing Screw
3. Strainer-less pulp
4. Strainer-more pulp
5. Spinning Brush
6. Bowl
7. Base
8. Cleaning Brush
9. Pusher
10. Container
Note: Do not pre-operate before inputting ma-
terials or do not operate with an empty bowl.
Important: The hopper edge must point to close
sign on the base in order for the machine to ope-
rate properly (Fig 1).
8
2.2. Assembly instructions
Important: Prior to Assembling the juicer please
check this point: At the base of the bowl there
is a rubber stopper. When in place the stopper
ensures all of the juice only exits via the juice out-
let. Before Juicing always ensure that the rubber
stopper is firmly in place (Fig 2).
1. Assemble the bowl on the base (see Fig3).
Make sure the bowl is all the way into the shaft
of the base.
2. Choose which strainer you need to use. The Ye-
llow Strainer is a fine strainer and will reduce the
amount of pulp in your juice. The White Strainer
is a coarse strainer and will increase the amount
of pulp in your juicer.
Insert the strainer into the spinning brush. Align
the red dot on the strainer with the red dot on
the bowl and insert strainer +spinning brush into
the bowl. When the dots are correctly aligned the
strainer +spinning brush will lock in place (Fig 4).
Fig. 1
Fig. 2
Fig. 3
Fig. 3
13
EN