5. Switch the power button to "ON".
• Insert food slowly to allow juicer time to work.
• Do not overstuff the hopper or force food in.
The pusher is only to be used if food becomes
stuck.
6. When you are finished switch the power but-
ton to "OFF".
If the machine becomes clogged and inoperable:
1. Turn the machine off and press the reverse bu-
tton for a few seconds then try operating again.
Note: The reverse button works with a 'pulse'
motion.
2. If the reverse button does not work turn off the
machine and switch off at the power point. Di-
sassemble the unit to dislodge any material then
reassemble as per the instructions and try again.
How to disassemble and clean the unit:
1. Switch off the unit.
2. Twist the bowl and hopper as one piece to
the right so that the arrow on the hopper moves
away from the close position. Lift off (Fig. 9).
Fig. 9
3. Disassemble the parts in the order show by the
diagram (Fig 10).
→
Fig. 10
4. Use the brush to clean all of these parts tho-
roughly in warm soapy water then dry thorou-
ghly.
5. Use a damp cloth to wipe down the base of
the unit.
3. CLEAN TIPS
• Periodically remove the silicone brushes from
the spinning brush and clean thoroughly before
reassembling.
• Thoroughly clean immediately after each use to
minimize staining.
• Pull out the rubber stopper on the base of the
bowl to clean bowl effectively. Always ensure
the rubber stopper is re-inserted prior to juicing
otherwise it may cause a leak.
• Do not use harsh abrasives or chemicals to
clean the juicer.
• Do not clean in the dish washer.
4. TECNIC SPECIFICATIONS
• Input voltage: AC 220-240V
• Frequency: 50Hz
• Power: 150W
• Speed: 65rpm
• Max. Operation time: 30 minutes
→
15
EN