Publicidad
Idiomas disponibles
Idiomas disponibles
The operationof any
SAFETY
GLASSES
lawn mower can result
in foreign objects thrown
into the eyes, which can
result in severe eye dam-
age. Always wear safety glasses or
eye
shields while operating your lawn mower
or performing any adjustments
or repairs.
We recommend
a standard safety glasses
or wide vision safety mask worn over
spectacles.
HOW
TO USE YOUR
LAWN
MOWER
ENGINE SPEED
The engine speed was set at the factory
for optimum performance.
It is not adjust-
able.
ENGINE ZONE CONTROL
,I:I,CAUTION"
Federal regulations
require
an engine control to be installed on this
lawn mower in order to minimize the risk
of blade contact injury. Do not under
any circumstances
attempt to defeat the
function of the operator control. The blade
turns when the engine is running.
• Your lawn mower is equipped with an
operator presence control bar which
requires the operator to be positioned
behind the lawn mower handle to start
and operate the lawn mower.
TO OPERATE
DRIVE SYSTEM
.
To start forward motion, lift drive con-
trol bar up to handle.
•
To stop forward motion, release drive
control bar.
IMPORTANT:
Always keep drive control
fully engaged against handle when in use.
Operator presence control bar
TO ADJUST
CUTTING
HEIGHT
Raise wheels for low cut and lower wheels
for high cut, adjust cutting height to suit
your requirements.
Medium position is
best for most lawns.
•
To change cutting height, squeeze ad-
juster lever toward wheel. Move wheel
up or down to suit your requirements.
Be sure all wheels are in the same set-
ting.
NOTE: Adjuster is properly positioned
when plate tab inserts into hole in lever.
Also, 9-position
adjusters (if so equipped)
allow lever to be positioned between the
plate tabs.
LEVER BACKWARD
TO LOWER MOWER
Plate tab
LEVER FORWARD TO RAISE MOWER
Lever
TO CONVERT
MOWER
Your lawn mower was shipped ready to
be used as a mulcher.
To convert to side
discharging:
• Open mulcher door and install dis-
charge deflector under door as shown.
• Mower is now ready for discharging
operation.
• To convert to mulching operation,
dis-
charge deflector must be removed and
mulcher door must be closed.
DRIVE
CONTROL
CONTROL
ENGAGED
DISENGAGED
Open mulcher door
Discharge
8
Publicidad
