EarthQuake E43 Instrucciones De Ensamblaje página 5

IMPORTANT
THIS ENGINE USES A GAS/OIL MIXTURE. DO NOT
RUN ON STRAIGHT GAS ONLY, ENGINE DAMAGE
WILL RESULT.
A
CAUTION
po
NOT ALTER/MODIFY ENGINE OR AUGER:
AVOID INJURY! NEVER ALTER OR MODIFY THE
ENGINE FROM THE FACTORY. SERIOUS INJURY
OR DEATH MAY OCCUR IF ENGINE IS MODIFIED
OR ALTERED.
AVOID INJURY! WHEN WORKING ON OR REPLAC-
ING PARTS FOR THE ENGINE OR AUGER YOU
MUST ALWAYS DISCONNECT SPARK PLUG WIRE
FROM THE SPARK PLUG AND KEEP IT AWAY
FROM THE SPARK PLUG.
AVOID INJURY! ALWAYS WEAR HEARING PRO-
TECTION WHILE OPERATING ENGINE.
AVOID INJURY! PLEASE DO NOT START YOUR
EARTH AUGER UNTIL YOU HAVE READ THE PRE-
VIOUS SECTION OF THIS MANUAL. IF YOU HAVE
READ THESE, FOLLOW THE STEPS BELOW TO
START YOUR EARTH AUGER.
AVOID INJURY! NEVER STORE ENGINE WITH GAS
IN THE TANK INDOORS. FUEL AND FUEL VAPORS
ARE HIGHLY FLAMMABLE.
AVOID INJURY! NEVER MIX FUEL AND OIL DIRECT-
LY IN ENGINE GAS TANK. USE ONLY NON-METAL,
PORTABLE FUEL CONTAINERS APPROVED BY
THE UNDERWRITER'S LABORATORY (U.L.) OR
THE AMERICAN SOCIETY FOR TESTING & MATE-
RIALS (ASTM).
AVOID INJURY! AN ADULT MUST ALWAYS HANDLE
AND FILL THE ENGINE WITH FUEL.
AVOID INJURY! ALWAYS HANDLE FUEL IN A WELL
VENTILATED AREA, OUTDOORS, AWAY FROM
FLAMES OR SPARKS.
Earth -a - ualc - ee
ASSEMBLY INSTRUCTIONS AND PARTS EXPLOSIONS r
E43 Model
OPERATION
STEPS FOR WORKING ON ENGINE OR AUGER
Turn off engine switch.
Disconnect the spark plug wire from the spark plug.
Securely place the disconnected spark plug wire away from the
spark.plug and any metal parts. This must always be done or
arcing may occur between spark plug wire and metal parts.
Replace or repair the part on the engine or auger.
Check all parts that were repaired, or removed during repair,
that they are secure and fit correctly.
NOTE: All repair parts must come from the factory. Never
replace parts that are not specifically designed for the
engine or auger.
Replace spark plug wire.
PREPARING ENGINE FOR STARTING
Before starting your powerhead engine, make sure the black throttle
cable housing is seated all the way into the brass ferrule at the
engine side of the cable.
GAS AND OIL
Quality
To operate the engine, we recommend using "VIPER" brand 2 cycle
oil (Pfi( 300400) to ensure that the engine operates correctly
throughout the life of the engine. Use unleaded regular gas only.
Mixture
Run earth auger with a 50:1 ratio.
GAS OIL
RATIO
1 gallon
2.5 ounces
50:1
2 gallons
5 ounces 50:1
5 gallons 13 ounces
50:1
MIXING FUEL AND FILLING GAS TANK
Mixing Fuel
Fuel must be mixed in a container outside in a well ventilated
area.
Fill certified fuel container 1/4 full of recommended fuel.
Add recommended amount of 2 cycle oil.
Screw container cap on straight and tight.
Shake the container to mix fuel and oil.
Unscrew gas cap slowly to vent, add the remainder of fuel re-
quirements.
Wipe away any spilled fuel or oil and allow to evaporate before
moving or transporting.
800-345-6007
Parts Online
Page
5
S.
Ardisam.com