Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO STOP THE ENGINE
1.
To stop the engine, move the
throttle control lever to the "SLOW"
position, then move to the "STOP"
position (see Figure 18).
T_h_Je Co nt_l
re 18
2.
Pull out and remove the ON/OFF
key (see Figure 19). Keep the
ON/OFF key in a safe place. The
engine will not start without the
ON/OFF key.
f
(
FF Key
I
Figure 19
TO START ENGINE
Be sure that the engine has sufficient
oil. The snow thrower engine is
equipped with a recoil starter. Before
starting the engine, be certain that you
have read the following information.
_
ARNING: The starter is
equipped with a three-wire
power cord and plug and is
designed to operate on 120 volt AC
household current. It must be prop-
erly grounded at all times to avoid
the possibility of electrical shock
which may be injurious to operator.
•
Follow all instructions carefully
as set forth in the "To Start En-
gine" section.
•
Determine that your house wiring
is a three-wire grounded system.
Ask a licensed electrician if you
are not sure. If your house wire
system is not a three-wire system,
do not use this electric starter un-
der any conditions.
•
If your system is grounded and a
three-hole receptacle is not avail-
able at the point your starter will
normally be used, one should be
installed by a licensed electrician.
•
When connecting 120 volt AC
"Power
Cord", always connect the
cord to the Switch Box on the en-
gine first, then plug the other end
into the three-hole grounded re-
ceptacle. When disconnecting
"Power
Cord", always unplug the
end in the three-hole grounded re-
ceptacle first.
How To Start A Cold Engine
1. Be sure auger drive and traction
drive levers are in the disengaged
(RELEASED)
position.
2. Turn the rotary choke knob to the
CHOKE position (see Figure 20).
3. Depress the primer button three
times (see Figure 20).
F-021073L
17
Publicidad
