Publicidad
Idiomas disponibles
Idiomas disponibles
The regulations below must be carefully followed in order to avoid harm to the
operator and damage to the appliance.
DANGER:
•
To reduce the risk of fire, electric shock or injury, read and follow all safety
and warning instructions before use. This Vacuum Cleaner is designed to be
safe when used for cleaning functions as specified. In the event of damage
to electrical or mechanical components, it is necessary to repair the vacuum
cleaner and / or accessory concerned at a competent service center or the
manufacturer prior to use to avoid further damage to the appliance or injury
physical to the user.
•
Before connecting the appliance to the power outlet, check that the electrical
data on the nameplate corresponds to those of the power supply. The
appliance must only be powered by alternating current and with a voltage equal
to that indicated on the serial number plate.
•
The power cord outlet must be earthed.
•
The power supply cable supplied with the appliance must be used for the
aforesaid appliance and not for other appliances.
•
Check for damage to the connection line and the power plug before each use.
If the line is damaged contact a technician immediately to restore the correct
operation.
•
Connect the appliance only to an electrical connection installed by an electrical
installer in accordance with IEC 60364-1.
•
Never touch the power plug with wet hands.
•
Be careful that the power cord or extension cord will not be damaged by
passing, crushing, pulling or the like. Protect the cable from heat and contact
with sharp oils or edges.
•
Regularly make sure that the power cord is not damaged, for example with
cracks or aging. If a damage is detected, the cable must be replaced before
reusing the appliance.
•
Water splash protection and mechanical resistance must also be ensured even
after the cable or cable extension joints have been replaced.
•
Do not clean the appliance with a hose or high pressure water jet (risk of short
circuits or other electrical faults).
CAUTION:
The insertion transient causes a temporary voltage drop.
Under unfavorable network conditions, other equipment may be damaged.
These damages are expected if the network impedance is less than 0.15Ω.
GENERAL SAFETY REGULATIONS
CONNECTION TO THE ELECTRIC TAKING
21
Publicidad
