Isoplam L010001 Manual De Uso Y Mantenimiento página 23

• Conditions of use: room temperature between 0°C and 40°C , with relative humidity
between 30 and 95%.
• Polishing operations should only be carried out in areas where the passage
of unauthorised persons is prohibited. Signal the presence of work areas with
suitable signs.
• The socket for the machine power cable must have a prescribed earth connection.
• Avoid damaging the machine power cable by crushing or bending it, or by applying
stress.
• Attention: do not let the power cable come into contact with the rotating brush.
• The appliance does not cause harmful vibrations.
• If the appliance is used in dangerous areas (for example, gas stations), the
relative safety norms should be observed. The appliance must never be used in
environments with a potentially explosive atmosphere.
• Do not place any liquid containers on the appliance.
• In the event of a fire, use a powder extinguisher. Do not use water.
• Adapt the speed to the adhesion conditions.
• Avoid using the brushes while the appliance is at a standstill, so as not to damage
the floor.
• Do not knock against shelving or scaffolding, where there is a danger of falling
objects. The operator must always be equipped with the appropriate safety devices
(gloves, shoes, helmet, goggles, etc.).
• If the appliance does not work properly, check this is not caused by failure to
carry out routine maintenance. Otherwise, ask for intervention of the authorised
technical assistance centre.
• If you need to replace any components, request the ORIGINAL spare parts from
an Authorised dealer and/or Retailer.
• Restore all electrical connections after any maintenance interventions.
• Have the appliance checked by an authorised technical assistance centre every
year.
• When disposing of consumable materials, observe the laws and regulations in
force. When, after years of valuable work, your appliance needs to be finally
decommissioned, dispose of the materials contained in it appropriately, bearing in
mind that the appliance is made of fully recyclable materials.
• If the power supply cable gets damaged, the appliance must be stopped if it is
operating. Disconnect the plug from the power supply, and have the cable replaced
immediately by an authorised service centre.
• Before using the appliance, check that all the hatches and covers are positioned
as shown in this Use and Maintenance Manual.
• Only use the discs supplied with the device, or those specified in the Instruction
Manual. The use of other discs could compromise safety levels.
23