Craftsman 919.167243 Manual De Instrucciones página 10

Contents of Carton
1 - Air Compressor
2- Wheels
2 - Shoulder Bolts, 3/8-16
2 - Hex Nuts, 3/8-16
2 - Molded Foot Bumpers
2 - Screws, 1/4 x 1.50
1- Handle
1 - Handle Grip
2 - Screws, #10-16 x 1.00
Tools Required for
1 - 9/16" socket or open end
wrench
1 - 3/8" socket
installing Handles,
Wheels, and Molded Foot
The wheems
and handme do
not provide adequate cmearance,
stability or support for pulling the
unit up and down stairs or steps,
The unit must be lifted, or pushed
up a ramp.
1. Submerge handle grip into warm
soapy water to make installation
easier. Remove handle grip from
soapy water and slide onto
handle.
2.
Slide handle through holes in
compressor saddle onto tabs.
Secure with screws, one on each
side.
Compressor Saddme
HandRe Screw
It wHmbe necessary
to brace or
support one side of the unit when
installing the wheems because the
compressor will have a tendency
to tip,
3. InstalI one shoulder bolt
and one nut for each wheel.
Tighten securely. The outfit
wilI sit leve! if the wheels are
properly installed.
Wheel
4.
Clean and dry underside of
air tank Ieg opposite wheels.
Remove the protective strip from
the adhesive backed molded
foot bumpers. Attach the foot
bumpers to the bottom of Ieg
on each end. Press firmly into
place.
Molded Foot
A09706 10-ENG