Publicidad
Idiomas disponibles
Idiomas disponibles
Immediatelyprepareyour lawn mowerfor
storage at the end of the season or if the
unit will not be used for 30 daysor more.
Handle
bracket
LAWN
MOWER
When lawn mower is to be stored for a period
of time,
clean it thoroughly,
remove
all dirt,
grease, leaves, etc. Store in a clean, dry area.
1. Clean
entire lawn mower
(See
"CLEANING"
in the Maintenance
sec-
tion of this manual).
2.
Lubricate
as shown
in the Maintenance
section
of this manual.
3.
Be sure that all nuts, bolts, screws,
and pins are securely
fastened.
Inspect
moving
parts for damage,
breakage
and wear. Replace
if necessary.
4.
Touch up all rusted or chipped
paint
surfaces
sand lightly
before
painting.
HANDLE
You can fold your mower
handle for storage.
1.
Loosen
the two (2) handle
knobs on
sides of the upper
handle
and allow
handle
to fold down to the rear.
2.
Remove
the two (2) handle
knobs
and
carriage
bolts on sides of the lower
handle
and pivot entire
handle
as-
sembly
forward
and allow
it to rest on
mower.
3.
Reinstall
knobs and carriage
bolts to
lower handle
or handle
brackets
for
safe keeping.
• When
setting
up your handle from the
storage
position,
the lower handle will
require
manually
locking
into the mow-
ing position.
IMPORTANT:
When folding
the handle
for
storage
or transportation,
be sure to fold
the handle
as shown
or you may damage
the control
cables.
OI
MOWING
POSITION
control bar
\
FOLD
"-'-./_/
X
FORWARD ",
Upper
FOR
'.,
handle
STO RAG E
Knob
ENGINE
Maintenance,
repair,
or replacement
of the
emission
control devices
and systems,
which
are being done
at the customers
expense,
may be performed
by any non-road
engine
repair establishment
or individual.
Warranty
repairs
must be performed
by an authorized
engine
manufacturer's
service
outlet.
Handle
knob
FUEL
SYSTEM
IMPORTANT:
It is important
to prevent gum
deposits from forming in essential
fuel system
parts such as carburetor,
fuel filter, fuel hose,
or tankduring
storage.Alcohol
blended fuels
(called gasohol
or using ethanol
or methanol)
can attract
moisture
which leads to separa-
tion and formation
of acids during
storage.
Acidic
gas can damage
the fuel system
of
an engine
while in storage.
• Empty
the fuel tank by starting
the en-
gine and letting it run until the fuel lines
and carburetor
are empty.
• Never use engine
or carburetor
cleaner
products
in the fuel tank or permanent
damage
may occur.
• Use fresh fuel next season.
NOTE:
Fuel stabilizer
is an acceptable
al-
ternative
in minimizing
the formation
of fuel
gum deposits
during storage.
Add stabilizer
to gasoline
in fuel tank or storage
container.
Always follow the mix ratio found on stabilizer
container.
Run engine
at least 10 minutes
after adding
stabilizer
to allow the stabilizer
to reach the carburetor.
Do not empty the gas
tank and carburetor
if using fuel stabilizer.
ENGINE OIL
Drain oil (with engine warm) and replace
with clean engine oil. (See "ENGINE" in
Lower handle
the Maintenance
section of this manual).
16
Publicidad
