Publicidad
Idiomas disponibles
Idiomas disponibles
Immediately prepare your lawn mower for
storage at the end of the season or if the
unit will not be used for 30 days or more.
LAWN MOWER
When lawn mower is to be stored for a
period of time, clean it thoroughly,
remove
all dirt, grease, leaves, etc. Store in a
clean, dry area.
1. Clean entire lawn mower (See
"CLEANING"
in the Maintenance
section of this _nanual).
2. Lubricate as shown in the Mainte-
nance section of this manual.
3. Be sure that all nuts, bolts, screws, and
pins are securely fastened.
Inspect
moving parts for damage, breakage
and wear. Replace if necessary.
4. Touch up all rusted or chipped paint
surfaces; sand lightly before painting.
HANDLE
You can fold your lawn mower
handle
for
storage.
1. Loosen
the two (2) handle
knobs on
sides of the upper handle
and allow
handle to fold down to the rear.
2.
Squeeze
the bottom
ends of lower
handle
toward
each other
until pins in
handle
clear the brackets
and pivot
entire
handle
assembly
forward
and
allow it to rest on mower.
• When
setting
up your handle
from the
storage
position,
the lower
handle
will
require
manually
locking
into the
mowing
position.
IMPORTANT:
When
folding
the handle
for storage
or transportation,
be sure to
fold the handle
as shown
or you may
damage
the control
cables.
Operator
I
control bar
Fold
Lower
han_
Fold
backward
Mowing
position
sq
pin
J
3-Position
handle
adjustment
bracket
ENGINE
FUELSYSTEM
IMPORTANT:
It is important to prevent
gum deposits
from forming
in essential
fuel system parts such as carburetor, fuel
filter, fuel hose, or tank during storage.
Also, experience
indicates that alcohol
blended
fuels
(called gasohol or using
ethanol
or methanol)
can attract moisture
which leads to separation
and formation
of acids during storage. Acidic gas can
damage
the fuel system of an engine
while in storage.
1. Drain the fuel tank.
2.
Start the engine and let it run until the
fuel lines and carburetor
are empty.
• Never use engine
or carburetor
cleaner
products
in the fuel tank or permanent
damage
may occur.
• Use fresh fuel next season.
NOTE;
Fuel stabilizer
is an acceptable
alternative
in minimizing
the formation
of
fuel gum deposits
during storage.
Add
stabilizer
to gasoline
in fuel tank or
storage
container.
Always
follow the mix
ratio found
on stabilizer
container.
Run
engine
at least 10 minutes
after adding
stabilizer
to allow the stabilizer
to reach
the carburetor.
Do not drain the gas tank
and carburetor
if using fuel stabilizer.
ENGINEOIL
Drain oil (with engine
warm)
and replace
with clean
engine
oil. (See "ENGINE"
in
the Maintenance
section
of this manual).
CYLINDER
1. Remove
spark plug.
2.
Pour one ounce
(29 ml) of oil through
spark plug hole into cylinder.
3.
Pull starter
handle slowly
a few times
to distribute
oil.
164 . Replace
with new spark plug.
Publicidad
