Publicidad
Idiomas disponibles
Idiomas disponibles
OTHER
• Do not store gasoline from one season
to another.
• Replace your gasoline can if your can
starts to rust. Rust and/or dirt in your
gasoline will cause problems.
• If possible, store your unit indoors and
cover it to give protection from dust and
dirt.
• Cover your unit with a suitable protec-
tive cover that does not retain moisture.
Do not use plastic. Plastic cannot
breathe, which allows condensation
to
form and will cause your unit to rust.
IMPORTANT: Never cover mower while
engone and exhaust areas are still warm.
A CAUTION:Never
store the lawn mower
with gasoline in the tank inside a building
where fumes may reach an open flame or
spark. Allow the engine to cool before
storing in any enclosure.
TROUBLESHOOTINGCHART
PROBLEM
CAUSE
Doesnotsta_
1.
Di_
airfilte_
Loss of power
Poor cut -
uneven
2. Out of fuel.
3. Stale fuel.
4. Water in fuel.
5. Spark plug wire is
disconnected.
6. Bad spark plug.
7. Loose blade or broken
blade adapter.
8. Control bar in released
position.
9. Control bar defective.
1. Rear of lawn mower
housing or cutting blade
dragging in heavy grass.
2. Cutting too much grass.
3. Dirty air filter.
4. Buildup of grass, leaves,
and trash under mower.
5. Too much oil in engine.
6. Walking speed too fast.
1. Worn, bent or loose blade.
2. Wheel heights uneven.
3. Buildup of grass, leaves
and trash under mower.
CORRECTION
1. Clean/replace
air filter.
2.
Fill fuel tank.
3.
Drain tank and refill with
fresh,
clean fuel.
4.
Drain fuel tank and
carburetor and refill tank
with fresh gasoline.
5.
Connect
wire to plug.
6.
Replace
spark
plug.
7. Tighten
blade bolt or
replace
blade adapter.
8.
Depress
control
bar to
handle.
9.
Replace
control
bar.
1.
Set to "Higher
Cut"
position.
2.
Set to "Higher
Cut"
position.
3. Clean/replace
air filter.
4.
Clean
underside
of mower
housing.
5. Check oil level.
6. Cut at slower walking
speed.
1.
Replace
blade.
Tighten
blade
bolt.
2.
Set all wheels
at same
height.
3. Clean
underside
of
mower
housing.
17
Publicidad
