Aspes ACPT600BX Manual De Usuario página 5

INSTALLATION
WALL DRILLING AND BRACKET FIXING
C
Vertical reference line
As a first step, proceed with the following drawings:
A vertical line up to the ceiling or up to the upper limit, at the center of the area in which the hood

is to be fitted.
A horizontal line A at 790– 890 mm above the cooker top.

A horizontal line B at a X mm above the horizontal line A.

A horizontal line C at a 115mm below the horizontal line A .

Mark Points:
Mark a point (1) on the horizontal line A, 80 mm to the vertical reference line.

Repeat this operation on the other side , checking that the two marks are leveled.

Mark a point (2) on the horizontal line B, 60 mm to the vertical reference line.

Repeat this operation on the other side, checking that the two marks are on the same

horizontal line.
Mark a point (3) on the horizontal line C, 150 mm to the vertical reference line . Repeat

this operation on the other side , checking that the two marks are leveled.
Fix the brackets :
 Drill holes at the marked points with a ɸ10 mm drill bit.
 Insert the Wall Plugs 11 into the holes.
 Fix a Chimney fixing bracket 21 with 2 screws 10 (5 x 50) at the horizontal line B.
Screw 2 screws 10 (5 x 50) to Wall Plugs 11 at the horizontal line A; approximately the four fifth

length of the screws 10 (5 x 50) was screwed into the Wall Plugs 11, used for hook the hood.
150
(3) 150
EN-5