Indel TL27 Instrucciones De Uso página 26

CHANGING THE TEMPERATURE IN THE LEFT ZONE
- Press the SET button once and the temperature currently set for the left zone will start flashing on the display;
- While the temperature is flashing, press the UP button to increase it or the DOWN button to decrease it;
- Once the desired temperature is selected, wait 4-5 seconds for it to stop flashing. The display will once more show the
current temperature inside the left zone.
- The temperature in the left zone can be set within a range of from -12°C to +10°C, regardless of the temperature set in the
right zone;
ADJUSTING THE TEMPERATURE IN THE RIGHT ZONE
- Press the SET button twice and the temperature currently set for the right zone will start flashing on the display;
- While the temperature is flashing, press the UP button to increase it or the DOWN button to decrease it;
- Once the desired temperature is selected, wait 4-5 seconds for it to stop flashing. The display will once more show the
current temperature inside the right zone.
- The temperature in the right zone can be set within a range of from -18°C to +10°C, regardless of the temperature set in the
left zone;
SWITCHING OFF ONE ZONE
Either of the two zones can be switched off independently from the other.
It is advisable to switch a zone off if it is empty. This will maximise the refrigerator's cooling efficiency in the other zone;
SWITCHING OFF THE LEFT ZONE:
- Press and hold the 'SET' and 'UP' buttons until the temperature in the left zone switches off on the display (about 2 seconds);
- To turn the left zone back on, press and hold the 'SET' and 'UP' buttons at the same time until the temperature in the left
zone switches on again (about 2 seconds).
SWITCHING OFF THE RIGHT ZONE:
- Press and hold the 'SET' and 'DOWN' buttons at the same time until the temperature in the right zone switches off on the
display (about 2 seconds);
- To turn the right zone back on, press and hold the 'SET' and 'DOWN' buttons at the same time until the temperature in the
right zone switches on again (about 2 seconds).
CHANGING THE DISPLAY FROM °C TO °F
To change the display from °C to °F (or vice versa), press the SET button 4 times.
The display for the left temperature zone will start flashing °C/°F, depending on which unit of measurement is set.
Press the 'UP' and 'DOWN' buttons while the unit of measurement is flashing to switch from one to the other and then wait
until it stops flashing (4-5 seconds) to confirm the selection.
24 TL27_(DC)_IM_20220131