Eiko 7WP1 Serie Instrucciones De Instalación página 2

B. WALL MOUNT NSTALLATION
1
Turn off Power.
ON l k
OFF
l c c
5
Drill mounting holes with Lock the bottom shell on the
an electric drill. mounting seat with screws.
Connect the L,N and G wires
to the power supply.
WIRING SCHEMATIC
Black (line)
White (line)
Green (ground)
Yellow / Green (ground)
Note: refer to the wiring diagram included with the emergency battery if added to the fixture.
INSTRUCTIONS FOR CCT & WATTAGE SELECTABLE AJUSTABLE
Wattage Adjustable Instruction
Turn the wattage adjustable knob to a certain wattage gear. The power of the lamp will change to the corresponding wattage. Ajustable
wattage range 25% - 100%.
Note: Please turn off the power before adjusting the wattage.
Color Turntable Instruction
1. The color temperature of the lamp turns to 3000K when the switch is set to 3K.
2. The color temperature of the lamp turns to 4000k when the switch is set to 4K.
2. The color temperature of the lamp turns to 5000k when the switch is set to 5K.
Note: Please turn off the power before adjusting the wattage color temperature.
2
2
Use a screwdriver to remove the
screws on both sides and remove
the upper cover of the fixture.
.
6
.
WFC1 Driver
TWP1 Driver
©2023 EiKO Global, LLC. World Headquarters: 18000 W. 105
Head Office, Canada: 7900 Goreway Drive, Unit 8, Brampton, ON L6T 5W6 1.888.741.2675
3
Use a screwdriver to remove the
plug.
7
Mount the cover of the fixture.
Street, 3
th
4
Drill mounting
an electric drill. Push the ex-
pansion rubber plug into the
mounting hole on the wall.
8
Fix the fixture with screws. Make sure the installation is
complete before turning on the
power switch.
Optional
Purple (Dim+)
0-10V
Gray (Dim-) Dimmer
Cover connector
To LEDs cover
Floor, Olathe, KS 66061 1.800.852.2217
rd
holes with
9
ON
l k
OFF
l c c
1.
eiko.com
Rev. 04/19/23