Philips CDI 220 Manual Del Propietário página 2

IMPORTANT NOTE
ADVARSEL!
Lithiumbatteri - Eksplosionsfare ved fejlagtig handtering.
Advarsel:
Udskiftning ma kun ske med batteri
af samme fabrikat og type.
Lever det brugte batteri tilbage til Ieveranderen.
Usynlig Iaserudstraling ved abning naar sikkerhetsafbrydere er ude af
funktion. Undga utsrettelse for straling.
Bemrerk:
ADVARSEL!
Lithiumbatteri- Eksplosionsfare.Udskiftning ma kun
foretages af en sagkyndig,
Netafbryderen POWER er sekundrert indkoblet og afbryder ikke
strommen fra nettet. Den indbyggede netdel er derfor tilsluttet til Iysnettet
sa Irenge netstikket sidder i stikkontakten.
og som beskrevet i servicemanualen.
Observer:
Nettbryteren POWER er sekundert innkoplet. Den innebygde netdelen er derfor ikke frakoplet
nettet sa Ienge apparatet er tilsluttet nettkontakten.
Klass 1 Iaserapparat
Vaming!
Orn apparaten anvands pa annat satt an i denna bruksanvisning specificerats, kann anvandaren
utsattas for osynlig Iaserstralning, som overskrider gransen for Iiiserklass 1.
Observera!
Strombrytaren POWER ar sekundart kopplad och inte bryter strommen fran natet. Den
inbyggda natdelen ar darfor ansluten till elnatet sa Iange stickproppen sitter i vagguttaget.
Luokan 1 Iaserlaite + Klass 1 Iaserapparat
Varoitus!
Laitteen kayttaminen muulla kuin tassa kayttoohjeessa mainitulla tavalla saattaa altistaa
kayttajan turvallisuusluokan 1 ylittavalle nakymattomalle Iasersateilille.
Huom.
Toiminnanvalitsin POWER on kytketty toisiopuolelle, eika se kytke Iaitetta irti sahkoverkosta.
Sisaanrakennettu verkko-osa on kytkettyna sahkoverkkoon aina silloin, k'Un pistoke on
pistorasiassa.
IMPORTANT NOTE FOR USERS IN THE UK
This apparatus is fitted with an approved 13 Amp plug.
To change a fuse in this type of plug, proceed as follows:
How to connect a plug
J. Remove fuse cover and fuse.
2. Fi.x new fuse which should be a BS1362 3A, A.S.T.A. or BSI approved
type.
3.
Ret1t the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should be cut off
and an appropriate plug fitted in its place.
If the mains plug contains a fuse, this should have a value of 3A. If a plug
without a fuse is used, the fuse at the distribution board should not be
greater than 3A.
NOTE
The severed plug must be destroyed to avoid a possible shock
hazard should it be inserted into a 13A socket.
111e wires in the mains lead are colored in accordance with the following
code:
Blue - 'Neutral' ('N'); Brown - 'Live' ('L')
1.
The Blue wire must be connected to the terminal which is marked with
the letter 'N' or colored Black.
2. The Brown wire must be connected to the terminal which is marked with
me letter 'L' or colored Red.
3. Do not connect either wires to the earth terminal
fn
the plug which b
marked by the letter 'E' or by the safety earth ~1mbol or colored green or
green-and-yellow.
Before replacing the plug cover, make certain that the cord grip is clJmped
over the sheath of the lead - not simply over the two wires.