Publicidad
Idiomas disponibles
Idiomas disponibles
Do not overtighten.
Overtightening
could strip the screw
holes.
Do not operate the cleaner without
the screw in place,
1
CORD ASSEMBLY
Make sure the quick release cord hook is in
the upright position. Remove the wire tie
from the power cord°
Notcl7
Lock the cord into
place by forcing it
into the locking
notch on the body
of the quick
release cord hook
as shown° This
helps keep the
power cord out
from under the
vacuum cleaner
agitator.
Wrap the
power cord
around the
quick release
cord hook
and lower
cord retainer,
then lock the
power cord
plug onto the
power cord.
Quick
Re/ease
Cord
Hook .,_,
Power
Cord --_
Lower
Cord
ATTACHMENT STORAGE
After the handle has been assemNed
to the
body and the power cord has been wrapped
around the cord hooks, the attachments
can
be placed in their holders.
1. Snap the suction inlet end of the hose
into the back of the vacuum cleaner,,
2. Place the hose behind the handle and
over the hose holder,
3. Place the hose in the front slot of the
tool holder, twisting and pushing down over
the short hose to assure a good connection,,
4. Place the extension
wand in the rear slot
of the tool holder,,
5, Slide the crevice toot into the slot beside
the wand_
6. Place the dusting brush or combination
brush on the wand with the brush portion
up.
Dusting
Brush
--
Extension
Wand
Suction
Inlet
Tool
Holder
Tool
6
Publicidad
